I just purchased a nano+ and I am having an issue with the gimbal. My initial searches show a few articles claiming there are or were widespread issues with the gimbal on these. I figured I would post here and see if this is indeed a common issue and whether I should be returning it.
From the start right out of the box after the self check, the gimbal is skewed left and is stuck in a self checking loop. After many restarts, it finally managed to center the gimbal. Upon flight there appears to be some brief stickage before it corrects itself when banking left or right. No matter how level the surface is, the majority of the time the gimbal fails to self initialize. Gimbal calibration will not exceed 55% and has failed the numerous times I have tried it. If I twist the gimbal slightly to the right before powering on, it will self initialize fine most of the time. Sticking with banking still exists and the gimbal calibration still fails at 55%. I have noticed that during the calibration when returning back from the right skew, it does seem to sorta drop back down rather then move smoothly like it does from the left.
Is there anything further that can be done on my end? Many thanks..
From the start right out of the box after the self check, the gimbal is skewed left and is stuck in a self checking loop. After many restarts, it finally managed to center the gimbal. Upon flight there appears to be some brief stickage before it corrects itself when banking left or right. No matter how level the surface is, the majority of the time the gimbal fails to self initialize. Gimbal calibration will not exceed 55% and has failed the numerous times I have tried it. If I twist the gimbal slightly to the right before powering on, it will self initialize fine most of the time. Sticking with banking still exists and the gimbal calibration still fails at 55%. I have noticed that during the calibration when returning back from the right skew, it does seem to sorta drop back down rather then move smoothly like it does from the left.
Is there anything further that can be done on my end? Many thanks..