Anyone had issues calibrating their drone? I get past the 1st of 2nd part but when it comes time to do the nose down part it'll fail everytime and flash yellow. I'm not near any electrical interference either. Any input would be great. BTW I've got the latest firmware as well.
Calibration issues
- Thread starter evilleautel
- Start date
Jagerbomb52
Well-Known Member
Ya with every beta and the final I have had problems with the second part. What I have started doing is just spinning the quad around instead of my whole body and it works every time now. That was recommended by one of the Autel people.
QuadSquad
Well-Known Member
- Joined
- Sep 4, 2017
- Messages
- 250
- Reaction score
- 66
- Age
- 63
You also can try:
As you hold the drone out in front of you, nose down, change the elevation, by lifting it up, and dropping it down lower. Most times I have to do that, to get a lock.
As you hold the drone out in front of you, nose down, change the elevation, by lifting it up, and dropping it down lower. Most times I have to do that, to get a lock.
Jagerbomb52
Well-Known Member
Good point
The last time I ended up using butcher twine tied to the back so it was centered and spun it like a top lol
Worked perfect and I did not get dizzy and fall down
The last time I ended up using butcher twine tied to the back so it was centered and spun it like a top lol
Worked perfect and I did not get dizzy and fall down
Similar threads
Latest threads
-
-
-
what is the procedure for replacement with serial number change?
- Started by mhassell
- Replies: 0
-
-
Members online
No members online now.