Hi
I have had an Evo II pro with standard controller that I also bought a dual 640T for and recently I bought an Evo II V2 Enterprise with extras.
I have a $100K job that I am about to lose to some kids with DJI Mavics.
For note, I have been building and using heavy lift drones (sub 50kg) since 2014.
I am doing terrain following (UGCs created) recon flights in the bush for a major international construction company using Thermal pre-dawn flights and then flying the same waypoint missions with RGB after sun up. I had the international CEO with me on my first flights at 4am in the morning and the Evo II Enterprise V2 did not perform like a $16 000 instrument.
These are basic things that the Evo II V2 should have no problems with. Does Autel care about their customers that spend bucket loads on their gear only to lose work and look stupid in front of your business.
Does Autel have any plan to fix these basic issues anytime soon as I have spent a bucket load of money on Autel products and am now loosing buckets more on business to millennials with DJI toy drones.
I have had an Evo II pro with standard controller that I also bought a dual 640T for and recently I bought an Evo II V2 Enterprise with extras.
I have a $100K job that I am about to lose to some kids with DJI Mavics.
For note, I have been building and using heavy lift drones (sub 50kg) since 2014.
I am doing terrain following (UGCs created) recon flights in the bush for a major international construction company using Thermal pre-dawn flights and then flying the same waypoint missions with RGB after sun up. I had the international CEO with me on my first flights at 4am in the morning and the Evo II Enterprise V2 did not perform like a $16 000 instrument.
- Its stopped recording on waypoint 2 every time even though the action in the waypoint for waypoint 2 was to do nothing. There was no camera action associated to it. This caused me to lose valuable data and look stupid in front of the CEO. The general parameters had camera action set to “- -". first waypoint was set to start recording and last waypoint was set to stop recording all other waypoints had no camera actions.
- I have a V60 SD card in it and it keep stopping recording or stating that the SD card is too slow. Again, valuable data was not captured for the CEO who was not impressed. I was recording at 4k 30 frames not even 8K.
- I lost signal continuously and sometimes it would stop recording during signal loss and I would not know that it had done this until I regained reception and objects I was supposed to capture were not recorded. CEO again not impressed.
- The elevation slider bar is set from 10 to 800 making it very difficult to change from 45 to 50m. I looked stupid again in front of CEO
- I had 60 waypoints and it slows down and stops at every waypoint losing about 10 seconds on every waypoint costing me valuable flight time. Why cant this very expensive aircraft just fly through waypoints like every toy drone out there?
- When the thermal cross hair is activated, none of the screen is accessible on the tablet as when you try do something like drop down the top menu, all it does is move the crosshair to where you tapped the screen.
- The 640T does not have an 8K RGB camera. I took frame grabs filming at the same distance and 8K is the worst resolution, followed by 6K. 4K is the highest but realistically, it’s just a standard 1080 camera that resamples the imagery to higher resolution and add massive amounts of compression that just makes everything blurry.
These are basic things that the Evo II V2 should have no problems with. Does Autel care about their customers that spend bucket loads on their gear only to lose work and look stupid in front of your business.
Does Autel have any plan to fix these basic issues anytime soon as I have spent a bucket load of money on Autel products and am now loosing buckets more on business to millennials with DJI toy drones.