- Joined
- Nov 21, 2021
- Messages
- 4
- Reaction score
- 1
OK so here is my dilemma. I purchased New an EVO II V1 a year ago and then this past May a V1 Smart Controller along with a Live Deck. To my surprise everything worked great until recently. A month ago I picked up a very nice EVO I with 4 Batteries, controller and Authentic Autel hard case for $400.00. So again to my surprise when I paired it to my Smart Controller everything worked great.. Now to my problem, after my third flight with my EVO I using the smart controller I was informed of a Firmware update (1.5.8) was required. Before updating I confirmed both my system software and App Software were up to date per my Smart Controller via Over-Air. so I then proceeded to accept the 1.5.8 update. after everything competed I rebooted both the EVO I and Smart Controller and this is where the problems began. The Smart controller no longer connects with either my EVO I or my EVO II v1 but they do connect with their standard controllers respectively. Unfortunately I didn't capture any of the versions of software for in my EVO I or EVO II prior to the 1.58 update. I attempted to roll back the EVO I but with no success. I attempted a SMART CONTROLLER Factory Reset with no success. Any Assistance I can get to get them both working on my $1200. SMART BRICK would be greatly appreciated.
EVO I on Firmware 1.5.8 - Complete and as directed by AUTEL TECH SUPPORT.
EVO II on Firmware 2.7.25 - Complete and as directed by AUTEL TECH SUPPORT.
EVO I on Firmware 1.5.8 - Complete and as directed by AUTEL TECH SUPPORT.
EVO II on Firmware 2.7.25 - Complete and as directed by AUTEL TECH SUPPORT.
Last edited: