Busdriver
Well-Known Member
Maybe something, maybe not.The built in nut ones for the DJI phantoms are the same props so I am wondering if it is a problem for the phantoms also. The motor shaft might be a different length and not causing them any issues. With the quarter inch flat washer I added shortens the motor shaft so the nuts can tighten right down. All they need to do is make a change on how deep the nuts get recessed into the prop and that would correct the problem I would think.
On both of my set of props, I noticed that they did not "spin down" as easily as the OEM props did. A little pressure once the prop stopped spinning, allowed me to make about 2-3 turns more and they seated fully. If I had stopped tightening them when I felt resistance, they would likely have wobbled also.
I haven't removed them since i installed them out of the box. I just removed one of the props and they spin down smoothly and fully now.
Something to think about perhaps?? Word of caution, I wouldn't want you to strip the threads on the shaft.